84Xx Series Configuration; Configuration Method; System Level Configuration; Configure Network Settings - Cisco BroadSoft BroadWorks Spectralink 84 Series Configuration Manual

4

84xx Series Configuration

This section describes the configuration settings required for the 84xx Series integration
with BroadWorks, primarily focusing on the SIP interface configuration. The 84xx Series
configuration settings identified in this section have been derived and verified through
interoperability testing with BroadWorks. For configuration details not covered in this
section, see the Spectralink 84-Series Wireless Telephone Administration Guide [1].
4.1

Configuration Method

The Spectralink 84xx series phones are typically configured using configuration files using
the FTP, FTPS, HTTP, HTTPS, or Trivial File Transfer Protocol (TFTP) protocol. The
following examples describe how to set the parameters using a configuration file. This
configuration description assumes the Spectralink 84xx Series phone is already
connected to a Wireless network (see the Spectralink Quick Network Connect (QNC)
Administration Guide [2]) and uses the Dynamic Host Configuration Protocol (DHCP) to
obtain an IP address, default gateway, DNS Server, Provisioning Server, NTP server, and
NTP Offset values. For more information on automated provisioning, see the Spectralink
84-Series Wireless Telephone Administration Guide [1].
The capabilities of the Spectralink 84xx phones have been verified for use with
BroadWorks based on the settings described in the following table. For more information
on the meaning, purposes, and applicability of the individual configuration items, see the
Spectralink 84-Series Wireless Telephone Administration Guide [1].
Configuration Files
84xx Series Configuration Files
Slnk84.sip.ld
000000000000.cfg
site.cfg
<MACaddress>-ext.cfg
4.2

System Level Configuration

This section describes system-wide configuration items that are generally required for
each 84xx Series to work with BroadWorks. Subscriber-specific settings are described in
the next section.
4.2.1

Configure Network Settings

This configuration description assumes the Spectralink 84xx Series phone is already
connected to a Wireless network (see the Spectralink Quick Network Connect (QNC)
Administration Guide) and uses the Dynamic Host Configuration Protocol (DHCP) to
obtain an IP address, default gateway, DNS Server, Provisioning Server, NTP server, and
NTP Offset values. For more information on network provisioning via DHCP, see the
Spectralink 84-Series Wireless Telephone Administration Guide [1].
BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK 84XX SERIES
© 2018 BROADSOFT INC.
Level Description
System Contains the device firmware load.
System Contains list of configuration files for all
devices and individual device settings.
System Contains configurable parameters that
apply to all devices in a given
deployment.
Subscriber Contains configurable parameters that
apply to an individual device in a
deployment.
20-BD5605-00
PAGE 18 OF 34