Configure Sip Interface Settings - Cisco BroadSoft BroadWorks Spectralink 84 Series Configuration Manual

4.2.1.1 Configure IPV6 Settings
Spectralink 84xx Series currently does not support IPv6.
4.2.2

Configure SIP Interface Settings

Step
System configuration file site.cfg
Step 1
Step 2
Step 3
Step 4
Step 5
BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK 84XX SERIES
© 2018 BROADSOFT INC.
Command
Configure the FQDN of the SIP Proxy:
Example:
reg.1.server.1.address="as.iop
1.broadworks.net"
Alternatively, you may use:
voIpProt.server.1.address="as.
iop1.broadworks.net"
Configure the SIP re-registration interval.
Example:
reg.1.server.1.expires="3600"
Alternatively, you may use:
voIpProt.server.1.expires="360
0"
Configure the Spectralink 84xx to support
the Diversion header.
Example:
voIpProt.SIP.header.diversion.
enable="1"
(Optional) Configure an Outbound Proxy
if a SBC is deployed between the
Spectralink 84xx and BroadWorks.
Example:
voIpProt.SIP.outboundProxy.add
ress="
sbc1.iop1.broadworks.net"
(Optional) Configure Outbound Proxy
Failover Behavior when redundant
proxies are available.
Example:
voIpProt.SIP.outboundProxy.fai
lover.onlySignalWithRegistered
="0"
voIpProt.SIP.outboundProxy.fai
lover.failback.mode="newReques
ts"
voIpProt.SIP.outboundProxy.fai
lover.reRegisterOn="0"
Description
Set the SIP server to the Fully Qualified
Domain Name (FQDN) of the
BroadWorks Application Server cluster.
This FQDN must match the domain
configured for the BroadWorks
subscriber's line/port domain.
The reg.x parameter is preferred for
single registrations per phone and may
be duplicated such that
reg.2.server.1.address could be used for
the second registration and so on.
However, the voIpProt parameter can be
used to cover all registrations on the
phone.
The phone's requested registration
period in seconds.
The reg.x parameter is preferred for
single registrations per phone and may
be duplicated such that
reg.2.server.1.expires could be used for
the second registration and so on.
However, the voIpProt parameter can be
used to cover all registrations on the
phone.
BroadWorks supports sending/receiving
redirected call information by use of the
diversion header.
If voIpProt.SIP.header.diversion.enable
is set to 1, the diversion header is
displayed if received.
Set the Outbound Proxy to the Session
Border Controller (SBC) if one is
deployed between the Spectralink 84xx
and BroadWorks.
If there are redundant SBCs, set it to the
FQDN for the SBC cluster.
These parameters configure failover
behavior related to the Outbound proxy.
20-BD5605-00
PAGE 19 OF 34