Configure The Settings Relating To Stream [Image] - Panasonic WV-X5550LT Operating Instructions Manual

2.5.3 Configure the settings relating to Stream [Image]

Click the [Image] tab on the "Image" page. (®page 19, page 20)
Configure the settings relating to H.265 (or H.264) image such as "Max bit rate (per client)", "Image capture
size", "Image quality", etc. in this section.
All stream settings
In this section setting items for all common stream settings are configured.
[Stream encoding format]
Selects the encoding format for transmitted streams.
•
H.265: Transmits H.265 images.
•
H.264: Transmits H.264 images.
•
Default: H.265
[Internet mode]
Select "On" when transmitting H.265 images (or H.264 images) via the Internet. It is possible to transmit stream
without changing the broadband router settings configured for JPEG image transmission.
•
On: H.265 images (or H.264 images) will be transmitted using the HTTP port. Refer to page 59 for further
information about the HTTP port number settings.
•
Off: H.265 images (or H.264 images) will be transmitted using the UDP port.
•
Default: Off
Note
•
When "On" is selected, only "Unicast port (AUTO)" will be available for "Transmission type".
•
When "On" is selected, it may take time to start displaying stream images.
•
When "On" is selected, stream images may not be displayed depending on the number of the
concurrent access user, etc.
•
When "On" is selected, only IPv4 access is available.
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".
•
Available value: 1-254
*2
2 Settings
Operating Instructions 31