11 Configure the settings relating to images
[Image]
The settings relating to JPEG and H.264 images such as the settings of image quality, etc. can be configured
on this page.
The "Image" page has the [JPEG/H.264] tab and the [Image quality] tab.
11.1 Configure the settings relating to the image
capture mode [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image" page. (®page 36, page 38)
[Image capture mode]
Select an image capture mode from the following.
SBV131
2 mega pixel [16:9]
2 mega pixel [4:3]
3 mega pixel [4:3]*
*Used by super resolution techniques.
•
Default: 2 mega pixel [16:9]
SBV111
1.3 mega pixel [16:9]
1.3 mega pixel [4:3]
•
Default: 1.3 mega pixel [4:3]
IMPORTANT
•
The positions of areas may move out of alignment when the "Image capture mode" setting is changed
when the following area settings are configured. Therefore we recommend that you configure each
area setting after configuring the "Image capture mode".
–
mask area (®page 84)
–
privacy zone (®page 89)
–
VMD area (®page 105)
–
VIQS area (®page 91)
–
Cropping outlines (®page 113)
Note
•
When "On" is selected for "VIQS" and the setting value for the aspect ratio is changed from "4:3" to
"16:9", make sure that the VIQS setting value does not exceed the maximum designated range.
11 Configure the settings relating to images [Image]
Operating Instructions
69