Moulinex companion xl Manual page 39

PROBLEMS
Excessive noise during
operation
Leak through lid.
Leak from the driver in
the bowl or from the XL
base accessory.
The blades do not ro-
tate easily.
Smell from motor.
"STOP" is displayed.
"SECU" is displayed.
"SECU" is displayed + red
indicator light is flashing.
"Err1" is displayed.
+ red indicator light is
flashing.
"Err2" is displayed.
"Err3" is displayed.
"Err4" is displayed.
Display "Err8"
"ntc1" is displayed.
+ red indicator light is
flashing.
"ntc2" is displayed.
+ red indicator light is
flashing.
CAUSES
The use of a wrong accessory
Volume of ingredients too high.
The lid is not correctly positioned or
locked.
The lid seal is not present.
The lid seal is cut or damaged.
Accessory error.
The bowl seal (D4) is not correctly po-
sitioned.
The bowl seal is damaged.
The locking ring (D6) is not locked
correctly.
Pieces of food that are too big or too
hard.
On using the appliance for the first time,
or in the event of overload of the motor
caused by too large a quantity of ingre-
dients or by pieces that are too hard or
too big.
The appliance has detected too many
vibrations and has changed to the
safety mode.
Motor overload caused by too many
ingredients or pieces which are too
hard or too large or overuse without
sufficient cooling down time.
Overheating of temperature sensors.
The heating element is not working.
Electronic fault.
Speed fault.
Communication fault with chopper
electronic card.
Safety locking sensor fault
Temperature sensor 1 is no longer
working.
Temperature sensor 2 is no longer
working.
Please use an adequate accessory (e.g.:
do not use the beater F3 for kneading
or mixing the dough, use the knife F4).
For this, refer to the recommendations
in the recipes and the operating ins-
tructions provided in this manual.
Reduce the quantity of ingredients
processed.
Lock the lid correctly on the bowl.
Position the seal on the seal holder and
clip the assembly to the lid.
Change the seal, contact an approved
service centre.
Check that you are using the
recommended accessory.
Position the seal correctly.
Contact an approved service centre.
Screw the ring in place (D6).
Reduce the size or quantity of the in-
gredients processed. Add some liquid.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Check that you are at the right speed
and that you are using the recom-
mended accessory.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Contact an approved service centre.
Check that the power pins under the bowl
are not clogged. If this is the case,
clean them and try again.
If that still does not work, contact an
approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an Approved Service Centre.
Contact an approved service centre.
Contact an approved service centre.
31
SOLUTIONS
EN