Table of Contents
Advertisement
Available languages
Available languages
On a Computer: In ON mode connect the camera with a
computer using the supplied USB cable. The device will be
shown as a flash drive and you can easily start viewing
images on the computer's screen.
3.6 Power off
Switch the ON/OFF lever to OFF position to power off the
camera. Please note that even in the OFF mode, the ca-
mera still consumes certain power at μA level. Therefore,
please remove the battery if the camera will not be used
for a long time.
4. Advanced operations
From the basic operations of the camera in the previous
chapter, we know that the camera has three basic opera-
tion modes:
1. OFF Mode:
Power switch is in OFF position.
2. ON Mode:
Power switch is in ON position.
3. TEST/SETUP
Mode:
Power switch is in "SETUP" position
The OFF mode is the specified safe mode for replacing
the SD-card or batteries and transporting the camera.
ATTENTION: Replace SD-card only in OFF mode!
4.1 Settings
To make any specific settings, an SD-card must be
inserted. Then, change into the TEST/SETUP mode as
explained before.
Below the display are the function keys with the following
functions:
• Press the menu key to switch between status mode or
Setup mode.
• In Status mode, the OK button is used to manually take
photos or videos, in the setup mode, confirm the setting
by pressing the OK button.
• In Setup mode the keys
menus, set values for date / time value.
or
are used to select sub-
EN
39
Advertisement
Table of Contents
