Honda EU10iT1 Manual page 104

dummyhead dummyhead
SHROUD REMOVAL/INSTALLATION
Remove the following:
– Fan cover (page 9-4)
– Engine bed (page 13-2)
• When installing, route the tubes properly (page 2-8).
SHROUD INSULATOR (2)
WASHER (2)
HARNESS CLIP
BOLT
(5 x 10 mm)
HARNESS CLIP
BRACKET
SHROUD SEAL A
BREATHER TUBE
INSTALLATION:
Apply a bead Φ 1.0 mm ( Φ 0.04 in) [1]
of liquid sealant (Threebond
or equivalent) to the breather tube as
shown.
[1]
L. SHROUD
CARBURETOR
INSULATOR
DIAPHRAGM TUBE
® 1207B
10 mm (0.4 in)
GENERATOR/ENGINE REMOVAL/INSTALLATION
INSULATOR COLLAR D
SHROUD SEAL B
SCREW (4 x 6 mm) (3)
0.9 N·m (0.09 kgf·m, 0.7 lbf·ft)
INSULATOR GASKET
INSTALLATION:
Note the installation
direction shown, and install
properly. Do not reuse.
R. SHROUD
BOLT (5 x 10 mm) (4)
13-3