Function Introduction For Combination Buttons; Replacement Of Batteries In Remote Controller - Gree GPC07AM-K5NNA2B Owner's Manual

Introduction for buttons on remote controller
9
WiFi button
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is
turned on, the " WiFi " icon will be displayed on remote controller; Under status of
unit off, press "Mode" and " WiFi " buttons simultaneously for 1s, WiFi module will
restore to factory default setting.
●
This function is only available for some models.

Function introduction for combination buttons

Temperature display switchover function
Under OFF status, press "-" and "Mode" buttons simultaneously to switch temp-
erature display between °C and °F
Light function
Under switch-on or switch-off state, you may hold "+"and "FAN" buttons
simultaneously to set the lamp on or off and send the code. After being energized
the lamp is defaulted on.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
● As the signal will be interfered in the room with electronic fluorescent lamp,
conversion fluorescent lamp or wireless phone, please get closer to the air
conditioner when using the remote controller.
●
Replace new batteries of the same model when replacement is required.
●
When you don't use remote controller for a long time, please take out the
batteries.
10
signal sender battery
reinstall
remove
Cover of battery box