Table of Contents
Advertisement
Page 10
6.13 (156)
9.50 (241)
7.50 (191)
Figure 3-8 Charger Mounting Dimensions in Inches
(mm)
NOTICE
A separate 120 VAC control power supply is
required for the battery charger input. No connec-
tions between the transfer switch and battery charg-
er should be made.
34. Extender Cable
An extender cable provides a means for extending the
distance between the power switching panel and the logic
panel. This allows for remote mounting of the logic panel.
A. 48 inch (1.2 m)
B. 72 inch (1.8 m)
C. 96 inch (2.4 m)
D. 120 inch (3.0 m)
E. 144 inch (3.7 m)
Special lengths are available. Contact Cutler-Hammer.
37. Service Entrance
A. Provides transfer switch as suitable for service
equipment rating - A key operated selector switch
permits external, power operated service disconnec-
tion with external pilot light for disconnect indication,
also includes Option 16.
B. Same as A except includes ground fault protection.
41. Space Heater with Thermostat
A. 100 Watts
B. 200 Watts
C. 400 Watts
42. Seismic Withstand Capability
Provides transfer switch with seismic capability exceeding
the worst case Zone 4 required levels per both the Uni-
7.38 (187)
form Building Code and the California Building Code.
3.7 ENCLOSURE
The rugged steel switch enclosure is supplied with door
hinges to insure proper support of the door and door
mounted devices (Figures 3-9, 4-1 and 4-2). The hinges
have removable hinge pins to facilitate door removal. The
doors are supplied as standard with a key lockable han-
dle. Cable entry holes are the customer's responsibility.
Figure 3-9 Typical Mini Switch Enclosure
I.B. ATS-CP01
Effective 5/98
Advertisement
Table of Contents
