Can Interfaces; Device Configuration; Cs100 Firmware Update; Secure Connection To The Plus+1 Connect Portal - Danfoss PLUS+1 Connect CS100 Technical Information

Technical Information
PLUS+1 Connect CS100 IoT Gateway — Professional Install Only
Device Functions

CAN interfaces

Device configuration

CS100 firmware update

Secure connection to the PLUS+1 Connect portal

© Danfoss | October 2020
The device features 2 CAN Bus interfaces. The CAN interfaces meet the specifications CAN 2.0 A/B
protocol and the physical layer according to ISO 11898-2 high-speed up to 1 Mbit / s. The CAN interfaces
are operational only when existing power supply is energized. A support for CAN-FD is not possible.
The CS100 can be remotely configured from the Danfoss PLUS+1® Connect portal to monitor the
machine state, performance, and position. Both position and machine data are periodically transmitted
and stored to the Danfoss Data Portal.
You can load a firmware update to the CS100 via the Danfoss PLUS+1
update may reset the saved configuration to default. After the firmware update, load your configuration
to the device through the PLUS+1
CS100 always establishes a secure encrypted TLS connection to the PLUS+1 Connect portal. If, for specific
reasons, the encryption is a problem, please contact your Danfoss representative for possible solutions.
® Connect portal.
® Connect portal. The firmware
BC299456869228en-000101 | 15