Door Reversibility - Zanussi ZRB638FW User Manual

1
Important! The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow:
1
Brown:
3
Blue:
5
As the colours of the wires in the mains lead of this ap-
pliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter "E" or by the
earth symbol or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either
marked with the letter "N" or coloured black.
3. Connect the wire coloured brown to the terminal ei-
ther marked with the "L" or coloured red.
4. Check that no cut, or stray strands of wire is present
and the cord clamp
sheath.
5. Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS 1362) fuse must be
used.
Warning! A cut off plug inserted into a 13 amp
10
2
3
4
5
Earth
Live
Neutral
4
is secure over the outer
socket is a serious safety (shock) hazard. Ensure that it is
disposed of safely.
Rear spacers and levelling
3
In the bag with the docu-
mentation, there are two
spacers which must be fit-
ted as shown in the figure.
Slacken the screws and in-
sert the spacer under the
screw head, then tighten
again the screws.
Removing the shelf holders
Your appliance is equipped with shelf retainers that make
it possible to secure the shelves during transportation.
To remove them proceed
as follows:
1. Move the shelf hold-
ers in the direction of
the arrow (A).
2. Raise the shelf from
the rear and push it
forward until it is freed
(B).
3. Remove the retainers
(C).

Door reversibility

Warning! Before carrying out any operations,
remove the plug from the power socket.
2
. Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
2
1
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.