Page 3
• It is dangerous to alter the specifications or modify er, which may cause it to explode, resulting in dam- this product in any way. Any damage to the cord may age to the appliance. cause a short-circuit, fire and/or electric shock. •...
Service could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not • Any electrical work required to do the servicing of be discarded together with the urban refuse and rub- the appliance should be carried out by a qualified bish.
Place the fresh food to be frozen on the top compart- ment. Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appli- ance run at least 2 hours on the higher settings. Important! In the event of accidental defrosting, for example due to a power failure, if the power has been Air cooling...
How to use the EasyWater dispenser Internal components: Water dispenser cleaning procedure 1. Unblock the two stopping elements on the sides of the tank as shown in the pictures: – press the stopping elements in the middle and move it up –...
How to use the EasyWater dispenser • It is possible to hear some noises caused by air en- tering when the water left the reservoir. Refill the water tank • In case the water does not flow well, press the water lever once again.
Butter and cheese: these should be placed in special • lean foods store better and longer than fatty ones; airtight containers or wrapped in aluminium foil or pol- salt reduces the storage life of food; ythene bags to exclude as much air as possible. •...
at the back of the appliance, over the motor compres- Defrosting of the freezer sor, where it evaporates. The freezer compartment of this model, on the other It is important to periodically clean the defrost water hand, is a "no frost" type. This means that there is no drain hole in the middle of the refrigerator compartment buildup of frost when it is in operation, neither on the channel to prevent the water overflowing and dripping...
Problem Possible cause Solution Products prevent that water flows in- Make sure that products do not touch to the water collector. the rear plate. Water flows on the ground. The melting water outlet does not Attach the melting water outlet to the flow in the evaporative tray above the evaporative tray.
8. Open the door. Make sure that the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Force Center. Technical data Dimension Height...
Electrical Connection 5. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. Caution! Any electrical work required to install 6. Switch on the appliance. this appliance should be carried out by a qualified The appliance is supplied with a 13 amp plug fitted electrician or competent person.
2. Raise the shelf from the rear and push it forward remove the plug from the power socket. until it is freed (B). Important! To carry out the following operations, we 3. Remove the retainers (C). suggest that this be made with another person that will Door reversibility keep a firm hold on the doors of the appliance during the operations.
Page 14
household waste disposal service or the shop where you purchased the product.
Need help?
Do you have a question about the ZRB834NW and is the answer not in the manual?
Questions and answers