What To Do If - Zanussi ZRB638FW User Manual

Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of
the refrigerator compartment every time the motor com-
pressor stops, during normal use. The defrost water
drains out through a trough into a special container at the
back of the appliance, over the motor compressor, where
it evaporates.
It is important to periodically clean the defrost water drain
hole in the middle of the refrigerator compartment channel
to prevent the water overflowing and dripping onto the
food inside. Use the special cleaner provided, which you
will find already inserted into the drain hole.

What to do if...

Caution! Before troubleshooting, disconnect the
power supply.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance is noisy.
The compressor operates con-
tinually.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator. The water outlet is clogged.
Possible cause
The appliance is not supported prop-
erly.
The Temperature regulator may be set
incorrectly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
Products prevent that water flows into
the water collector.
Defrosting of the freezer
The freezer compartment of this model, on the other hand,
is a "no frost" type. This means that there is no buildup
of frost when it is in operation, neither on the internal walls
nor on the foods.
The absence of frost is due to the continuous circulation
of cold air inside the compartment, driven by an auto-
matically controlled fan.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Check if the appliance stands stable (all
the four feet should be on the floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease to
room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Solution
7