Page 3
or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance.
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials.
Thawing Bottle rack Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temper- ature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer.
• do not store warm food or evaporating liquids in the • prepare food in small portions to enable it to be rapidly refrigerator and completely frozen and to make it possible subse- quently to thaw only the quantity required; •...
Many proprietary kitchen surface cleaners contain chemi- cals that can attack/damage the plastics used in this appli- ance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains sup- ply.
Page 8
Problem Possible cause Solution Water flows on the ground. The melting water outlet does not flow Attach the melting water outlet to the in the evaporative tray above the com- evaporative tray. pressor. There is too much frost and ice. Products are not wrapped properly.
2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Con- tact the Service Center. Technical data ZRB632FW ZRB634FW ZRB638FW Dimension Height 1750 mm 1850 mm 2010 mm Width 595 mm 595 mm...
Page 10
Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. Rear spacers You can find the two spacers in the bag with documenta- tion. Do these steps to install the spacers: 1.
Page 11
Door reversibility To remove them proceed as follows: Warning! Before carrying out any operations, remove the plug from the power socket. 1. Move the shelf hold- ers in the direction of Important! To carry out the following operations, we the arrow (A). suggest that this be made with another person that will 2.
Environmental concerns negative consequences for the environment and human The symbol on the product or on its packaging health, which could otherwise be caused by inappropriate indicates that this product may not be treated as waste handling of this product. For more detailed household waste.