Hide thumbs Also See for ZRB38212WA:


Quick Links

User Manual
EN User Manual
Fridge Freezer


Table of Contents

Summary of Contents for Zanussi ZRB38212WA

  • Page 1 User Manual GETTING STARTED? EASY. ZRB38212WA ZRB38212XA EN User Manual Fridge Freezer...
  • Page 2: Safety Information

    SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
  • Page 3: Safety Instructions

    Clean the appliance with a moist soft cloth. Only use neutral • detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a • flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the •...
  • Page 4: Operation

    • Do not put flammable products or items that are • Regularly examine the drain of the appliance and wet with flammable products in, near or on the if necessary, clean it. If the drain is blocked, appliance. defrosted water collects in the bottom of the •...
  • Page 5: Daily Use

    TEMPERATURE REGULATION • room temperature • frequency of opening the door To operate the appliance, touch the temperature • quantity of food stored regulator until the LED corresponding to the • appliance location. required temperature lights up. Selection is progressive, varying from 2°C to 8°C. 1.
  • Page 6: Care And Cleaning

    CARE AND CLEANING DEFROSTING OF THE REFRIGERATOR WARNING! Refer to Safety chapters. Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal CLEANING THE INTERIOR use. The defrost water drains out through a trough into a special container at the back of the Before using the appliance for the first time, the appliance, over the motor compressor, where it...
  • Page 7 WHAT TO DO IF... Problem Possible cause Solution The appliance is noisy. The appliance is not suppor- Check if the appliance stands ted properly. stable. The lamp does not work. The lamp is in stand-by mode. Close and open the door. The lamp does not work.
  • Page 8: Installation

    Problem Possible cause Solution The QuickFreeze function is Refer to "QuickFreeze function". switched on. Side panels of the appliance This is a normal state caused Make sure that there is at least are warm. by operation of the heat ex- 30 mm of space between each changer.
  • Page 9: Technical Data

    2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath.

This manual is also suitable for:


Table of Contents