Advertisement
Quick Links
Advertisement
Related Manuals for Pentair Hydromatic SKV50
Summary of Contents for Pentair Hydromatic SKV50
- Page 1 SKV50 Submersible Sewage Ejector Pump INSTALLATION AND SERVICE MANUAL pentair.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS: SECTION ........................................PAGE General Safety....................................3 Installation......................................4 Maintenance..................................... 5 Specifications....................................7 Parts List......................................8 Warranty......................................11... -
Page 3: General Safety
GENERAL SAFETY SAFETY SYMBOLS ELECTRICAL SAFETY This is the safety alert symbol. When you see this symbol DANGER Hazardous voltage. Can shock, burn, or kill. on your pump or in this manual, look for one of the following When installing, operating, or servicing this pump, follow the signal words and be alert to the potential for personal injury: safety instructions listed below. -
Page 4: Installation
Also, a minimum diameter of 24" is recommended. 10. Use pump partially or completely submerged for pumping (temperature to 140° F). The SKV50 will pump solid Make sure the sump is free of string, cloth, nails, gravel, etc. materials up to 2" (spherical) in diameter. -
Page 5: Maintenance
MAINTENANCE Servicing should be performed only by knowledgeable pump Now connect one meter lead to one blade terminal service contractors or authorized service stations. of stator and touch other meter lead to motor stator shell (4). If needle reads below 5 (500,000 ohms) stator Remove pump from sump: Before removing pump from must be dried out before reusing. - Page 6 MAINTENANCE Remove the stator: To remove the stator, remove the four 18. Oil: Fill the motor cap with high grade transformer oil just covering over stator end cap (.45 gallon). Do not fill hex head screws and disconnect the brown capacitor the motor housing completely –...
-
Page 7: Specifications
SPECIFICATIONS SKV50 Series - Cast Iron Individual Branch CORD Motor Full SOLIDS MODEL UPC # VOLTS SWITCH PHASE Circuit DISCHARGE LENGTH Load Amps HANDLING Required (amps) SKV50AW1 10-01 619872011184 10' (3.1m) Piggyback Tethered 12.0 20.0 2" NPT 2" (50.8 mm) -
Page 8: Parts List
Cord 115V 20' (6.1m) 146230201 146230201 Cord 230V 20' (6.1m) 146232201 Piggyback Tethered Float 145951101 Switch 115V 10' (3.1m) Piggyback Tethered Float 145951201 Switch 115V 20' (6.1m) • Not illustrated * 230 Volt SKV50 is manual only (no switch available). HYD880 (03-25-20) - Page 9 THIS PAGE IS LEFT BLANK INTENTIONALLY HYD880 (03-25-20)
- Page 10 THIS PAGE IS LEFT BLANK INTENTIONALLY HYD880 (03-25-20)
-
Page 11: Warranty
WARRANTY LIMITED WARRANTY Hydromatic ® warrants to the original consumer purchaser (“Purchaser” or “You”) of the products listed below, that they will be free from defects in material and workmanship for the Warranty Period shown below. WARRANTY PERIOD PRODUCT WHICHEVER OCCURS FIRST: 12 months from date of original installation, Submersible utility pumps and related accessories or 18 months from date of manufacture... - Page 12 293 WRIGHT STREET | DELAVAN, WI 53115 | PH: 866-957-6835 | ORDERS FAX: 800-426-9446 | PENTAIR.COM/HYDROMATIC For a detailed list of where Pentair trademarks are registered, please visit www.pentair.com/en/registrations.html. Pentair trademarks and logos are owned by Pentair plc or its affiliates. Third party registered and unregistered trademarks and logos are the property of their respective owners.