Door Reversal - Zanussi ZI 8 FF Instruction Booklet

Instructions for totally built-in
appliances

Door reversal

The appliance is supplied with the door
hinges on the right or on the left. To
change the opening direction of the doors
proceed as follows before installing the
appliance.
1. Gently lay the appliance on its back with the top
held away from the floor by 5-8 cm (2-3 inches) of
packaging;
2 Unscrew the upper pin and remove the spacer
3. Remove the upper door
4. Unscrew the pins (B) and the spacers (C) and
refit them on the middle hinge of the opposite
side. Snap the hinge cover (A).
5. Refit the upper door, the upper pin and the
spacer on the opposite side
6. Unscrew the lower pin and remove the spacer
and refit them on the opposite side
Recess dimensions
Height (1) 1780 mm
Depth (2) 550 mm
Width (3) 560 mm
To ensure adequate ventilation, allow the clearances
shown in figure.
Furthermore, it is necessary that the cabinet has a
ventilation recess with the following dimensions:
depth 50 mm
width 540 mm
16
min.
50 mm
2
200 cm
D567
3
2 1
PR01
A
C
B
min.
200 cm 2