Door Reversal Directions - Zanussi ZF67/35E Instructions For The Use And Care

Door reversal
directions
(Fig. 8 - Mod. ZF67/35 - Z20/9 E excluded)
Before carrying out the operations
described below, pull out the mains plug
from the wall socket.
To carry out this reversal go through the
following steps:
a) Remove base 2 by unscrewing its
front screws. Slide it downwards to
release it from the central runners.
b) Remove bottom hinge 1;
c) Unscrew pin C from hole A and screw
it down into hole B;
d) Slide out the lower door from middle
hinge;
e) Remove middle and top hinge 3 and 4
and refit them on the opposite side;
f) Refit the bottom door and hinge 1 on
the opposite side;
g) Turn base upside-down and refit it;
i) Remove handles 5-6 and refit them on
the opposite side.
Panelling the doors
(only for models with door frames)
Proceed as follows to fit the door panels:
Take off the removable section of the
door frame from the opposite side with
respect to the hinge after unscrewing the
securing screws;
Unloose, without removing them, all
securing screws of the door frame.
Slide in, on the side from which the
removable section of the door frame was
taken off, the covering panel and push it
in all the way.
Fasten again the frame to the door,
including the previously removed
detachable frame section.
Note:
The door panels of the refrigerator &
freezer compartments should have the
following dimensions:
Refrigerator: Width 598 mm
Height 792 mm
Thickness 4 mm
Freezer:
Width 598 mm
Height 617 mm
Thickness 4 mm
10