Table of Contents
Advertisement
Ventilation Requirements
The appliance must have adequate ventilation to ensure
correct operation.
Diagram shows the ventilation requirements when
installed:
A* Under a worktop, or cupboard.
*
The clearance space of 10 cm above the appliance
may be reduced to 5 cm providing a clearance space
2.5 cm is left on either side of the appliance.
B
When freestanding
Levelling
The appliance must be level. Level the appliance by
adjusting the two adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be removed.
Door Reversal
If required the opening direction of the door can be
changed as follows:
To reverse the bottom hinge assembly proceed as fol-
lows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of
the appliance on a stool or something similar.
Unscrew the adjustable feet situated on both sides at
the front (2 pieces). Remove the lower door hinge
plate by unscrewing the 2 retaining screws.
Remove the hinge pin from the bottom of the door.
Slot the hinge pin into the hole in the hinge plate and
relocate the hinge assembly to the opposite location
and refit using the retaining screws.
Put the cabinet in the upright position.
To reverse the top hinge assembly proceed as follows:
Remove the 2 worktop retaining screws from the
back of the appliance.
Slide the worktop towards the rear and lift clear of the
appliance.
Remove the 2 upper hinge plate retaining screws.
Remove the hinge plate from the top of the door.
Unscrew the hinge pin from the hinge plate and re-
insert on the opposite side of the pate.
Rotate the hinge assembly 180° and insert the hinge
assembly into the opposite location.
Refit the 2 hinge plate retaining screws.
Relocate the worktop and refit the worktop retaining
screws.
11
Advertisement
Table of Contents
