Connect Devices; Power Supply - WAGO 852-1112 Manual

28

Connect Devices

Pos : 25 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/Geräte ansc hließ en - Übersc hrift 1 @ 3\mod_1234172889468_21.doc x @ 27460 @ 1 @ 1
6 Connect Devices
Pos : 26 /Serie 852 (ETH ERNET-Zubehör)/Ansc hließ en/Ansc hlus s Spannungs vers orgung 852-1112 @ 27\mod_1471932636472_21.doc x @ 218977 @ 2 @ 1
6.1

Power Supply

The industrial ECO switch uses direct-current power supply for 9 ... 57 V.
The primary network link is established via a 2-pin plug-in connection located on
the top of the industrial ECO switch.
The female connector (order-no. 2231-102/026-000) is composed of two
connecting terminals and can be inserted and removed easily by hand to connect
to the 2-pin plug connector located on the top of the switch.
1. PWR +/- conductors:
To connect or disconnect the conductors, actuate the spring directly in the
female connector using a screwdriver or an operating tool and insert or
remove the conductor.
2. Plug the female connector into the male connector of the switch if it has not
already been plugged in.
3. Connect a suitable grounding conductor to the grounding lug on the top of
the industrial ECO switch.
Important note!
The ground for the industrial ECO switch prevents electromagnetic interference
from electromagnetic radiation.
Observe the corresponding standards for EMC-compatible installations as well.
4. Check whether the power LED on the top of the device lights up when
power is supplied to the device. If not, check to ensure that the power cable
is plugged in correctly and fits securely.
Pos : 27 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-ETHERNET-Zubehör 852
852-1112 8-Port 1000BASE-T-Industrial-Eco-Switch
Version 1.1.0FW/HW-Version 01/01
Manual