Connect Devices; Power Supply - WAGO 852-1111 Mounting, Installation And Handling

WAGO ETHERNET Accessories 852
852-1111 5 Port 1000BASE-T Industrial ECO Switch
6

Connect Devices

6.1

Power Supply

The industrial ECO switch uses direct-current power supply for 9 ... 48 V.
The primary network link is established via a power source located on the top of
the industrial ECO switch.
The terminal block is composed of three contact pins and can be inserted and
removed easily by hand to connect to the three-pin terminal block receptor (male
contacts located on the top of the switch).
1. PWR +/- conductors:
To connect or disconnect the conductors, actuate the spring directly in the
female connector using a screwdriver or an operating tool and insert or
remove the conductor.
2. Plug the female connector into the male connector of the switch if it has not
already been plugged in.
3. Connect a suitable grounding conductor to the grounding lug on the top of
the industrial ECO switch.
Important note!
The ground for the industrial ECO switch prevents electromagnetic interference
from electromagnetic radiation.
Observe the corresponding standards for EMC-compatible installations as well.
4. Check whether the power LED on the top of the device lights up when
power is supplied to the device. If not, check to ensure that the power cable
is plugged in correctly and fits securely.
Version 1.3.0, valid fromFW/HW Version 02/04
Connect Devices 29
Manual