6. Power Shelf Installation and Cabinet Connection
Install MCB(Miniature Circuit Breaker) on the Cable
※ MCB should be applied to all the DC cables to be installed.
① Peel off enough length of the
covering of AWG12 cable at the
proper point.
④ Tighten the built-in screw at
the front side of MCB using
cross driver not to cable be
drawn away from the MCB.
② Cut off enough length of
the one of two cables and
peel off the inner covering,
showing the copper cable a
little.
: Connected
I
: Blocked
O
⑤ Repeat this sequence to
the cable's other end and
MCB lower hole to make
cable's both sides connected
through MCB
Samsung Electronics
③
Insert the peeled copper
cable into the upper MCB hole.
※ Push the peeled cables fully
inside the hole of MCB for
your safety.
54