Samsung LH008IWJMWR Installation Manual page 49

5. Cabinet + Frame Installation
Samsung Electronics
◇ Aligning modules in X-, Y-axis directions
- After installing the Cover PCB on each edge, install the Holder PCB.
※ The Holder PCB is a device to prevent from being made gaps between modules.
① Install the Holder PCB after completing all alignment work using Cover PCB
② Assemble the Holder PCB on the outer surface of the screen.
③ Fasten the Holder PCB using M4L6 screws.
④ Install one Holder PCB on the outside of all modules located at the exterior.
Holder-PCB
Vertical center line
Horizontal center line
M4L6
Fig.1 HOLDER PCB Installation Fig.2 HOLDER PCB location on the cabinet
48