Philips dynalite DMRC210-RJ-DA Installation Instructions

...............................................................................................................................
DMRC210-RJ-DA
EcoSet Relay Controller
Installation Instructions
.........................................................................................................................
......
Installation Overview
Connect Data Cable in a 'Daisy Chain'
Serial Cable Termination
RJ12 connectors using flat cable recommended.
Double-adaptor (Y-splitter) is usable for spurs.
Electrical diagram
N N
DIPswitch
RJ12
Before installation or servicing,
disconnect power at circuit breakers or
remove fuses to avoid electrical shock
or damage to the unit. It is
recommended that an electrician
perform this installation.
To reduce the risk of fire or electric shock , do not expose this
device to rain or moisture.
Do not energise unless the front cover is in place. Network (DyNet)
wiring is SELV and must be double – insulated from mains in
accordance with the local wiring rules. Installation, programming
and maintenance must be carried out by qualified personnel.
No more than 60 DMRC210 units may be safely connected to a
single Dynet network without additional grounding precautions.
Supply:
230V
CH1 CH2
1 Phase
L
IN
out 20A
out
isolation barrier
(double-insulated)
µP
RJ12
DyNet
RS485
WARNING