humimeter FS1 & FS1.1 Operating Manual
4.
Using the device - Basics
4.1
Switching the device on
• Press the
»
The display will then show the status indicator
(figure 4).
»
After inserting the batteries, the device switches on
automatically.
4.2
Automatic calibration
»
The display will show the message Adjust?
(figure 5).
1.
Make sure that the measuring chamber of the de-
vice is empty and place the device on a level table.
2.
Confirm by pressing
»
The display will now appear as shown in figure 6.
»
The bar will run upwards. During this period, the
device must remain on the table without external
influence,
»
which only takes a couple of seconds to complete.
»
Once completed, the device will show the measuring window (see
selection menu" page
4.3
Accessing the main menu
To do so:
The devices is switched off.
• Switch on the device (see
• While switching on, keep both the
• The display will then show the main menu.
Page 14
button for 3 seconds.
.
5).
"4.1 Switching the device
4
5
6
on").
and
buttons pressed.
"Product