Table of Contents
Advertisement
Quick Links
PSWDI
LightSense
Wireless Incandescent Dimmer
™
Specifications
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . .120VAC, 60Hz
Maximum Load Rating . . . . . . . . . . . . . . . . . . . . . . . . . . . .600W
Minimum Load Required . . . . . . . . . . . . . . . . . . . . . . . . . . .60W
Load Type Compatibility . . . . . . . . . . . . . . . . . . . . . . . .60-600W
Incandescent (tungsten/quartz halogen) transformers
U.S. Patent 6,175,220. Other utility,
design, and foreign patents pending.
800.223.4185
Syracuse, NY 13221-4822
www.passandseymour.com
Advertisement
Table of Contents
Related Manuals for LEGRAND Pass & Seymour LightSense PSWDI
Summary of Contents for LEGRAND Pass & Seymour LightSense PSWDI
- Page 1 PSWDI LightSense Wireless Incandescent Dimmer ™ Specifications Operating Voltage ......120VAC, 60Hz Maximum Load Rating ......600W Minimum Load Required .
-
Page 2: Unit Description
UNIT DESCRIPTION The LightSense™ Wireless devices use radio signals to communicate with each other to control lighting and other types of electric loads in selected areas. LightSense wireless devices use the 900MHz band for high-speed control communication. Using the patented “frequency-agile” Top Dog™ technology, LightSense wireless devices avoid interference with other 900MHz devices, such as cordless phones and baby monitors. -
Page 3: Installation
TURN THE POWER OFF AT THE CIRCUIT BREAKER BEFORE INSTALLING THE DIMMER. INSTALLATION For ease of installation, Pass & Seymour/Legrand recommends use of a deep wall box. 1. Disconnect power to circuit by turning circuit breaker OFF before installation. 2. Remove existing wall plate and switch. -
Page 4: New Installation
SET HOUSE ID All LightSense™ wireless devices installed in the same home must acquire the same unique House ID before use. This process is known as house binding. Each LightSense wireless device is bound to all other LightSense wireless devices in the house. New Installation 1. -
Page 5: Operation
OPERATION Tap once Fade the load to its last-used level Tap twice Full bright – – Press and hold Increase the present level Tap once Fade the load to OFF – – Press and hold Decrease the present level When you see When you see in the in the... -
Page 6: Advanced Operation
ADVANCED OPERATION Groups Use a LightSense™ wireless incandescent dimmer in conjunction with one or more LightSense PSWCS Wireless Multilocation Controllers to control one lighting circuit from multiple locations. Binding the PSWDI and PSWCS devices together in the same Group enables them to work in exactly the same way, from any of the control locations. -
Page 7: Troubleshooting
CLEANING Clean using a cloth dampened only with water and a little mild detergent. Use of solvents or hydrocarbon-based cleaners may cause permanent damage. TROUBLESHOOTING During Set House ID, the LED is not flashing on some wireless LightSense™ devices. • If LED is solid green before initiating House ID binding: The device already has another House ID. -
Page 8: Fcc Notice
• Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by Pass & Seymour/Legrand could void your authority to operate this equipment. LIMITED FIVE YEAR WARRANTY Pass & Seymour will remedy any defect in workmanship or material in Pass & Seymour products which may develop under proper and normal use within five years from date of purchase by a consumer: (1) by repair or replacement, or, at Pass &...