Making Wi-Fi Settings By Push Button Setup (Wps) - Epson SC-F100 Series User Manual

User's Guide
5. Select the SSID for the wireless router.
Note:
❏ If the SSID you want to connect to is not displayed on the printer's control panel, press the
list. If it is still not displayed, press the
❏ If you do not know the network name (SSID) check if the information is written on the label of the wireless router. If
you are using the wireless router with its default settings, use the SSID on the label. If you cannot find any
information, see the documentation provided with the wireless router.
6. Enter the password.
Note:
❏ The password is case-sensitive.
❏ If you do not know the password, check if the information is written on the label of the wireless router. On the label,
the password may be written "Network Key", "Wireless Password", and so on. If you are using the wireless router
with its default settings, use the password written on the label.
7. When you have setup finished, select Start Setup.
8. Select Dismiss to finish.
Note:
If you fail to connect, load A4- or Letter-size plain paper, and then select Print Check Report to print a connection
report.
9. Close the network connection settings screen.
Related Information
"Basic Operations" on page 15
&
"Entering Characters" on page 17
&
"Checking the Network Connection Status" on page 28
&
"When You Cannot Make Network Settings" on page 106
&

Making Wi-Fi Settings by Push Button Setup (WPS)

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Select Wi-Fi on the home screen.
To select an item, use the
2. Select Wi-Fi (Recommended).
If the printer has already been connected by Ethernet, select Router.
Network Settings
button, and then enter the SSID directly.
u d l r
buttons, and then press the OK button.
23
button to update the