Physical Installation
4.1 Connecting the projector with the power net
CAUTION: Use only the power cord provided with the projector.
How to connect with local power net
1.
Ensure that the power switch stands in the '0' (OFF) position (1).
1
2
3
Image 4-1: Power input
2.
Connect the female side of the power cord with the power input socket of the projector (2).
3.
Secure the power plug by locking the plug holder clamp (3).
4.
Connect the male side of the power cord to the local power net.
Caution:
Ensure that the power net meets the power requirements of the projector.
WARNING: Do not attempt operation if the AC supply and cord are not within the specified voltage
and power range.
CAUTION: Once the projector is switched to standby, the lamp cooling fans will continue to run for
approximately five minutes to ensure that the projector and lamp have sufficiently cooled, at which
point the fans will automatically decrease to standby. To avoid thermal stress that can lead to
premature lamp failure, never unplug the power cord while the lamp cooling fans are running. Never
unplug the power cord to power down the projector, first switch off the power switch and then unplug
the power cord.
Fuses
The projector is protected with an automatic circuit breaker of 20 A which is built into the power switch.
38
R5906070-11
HDX 4K