Table of Contents
Advertisement
Specification Notes
SPECIFICATION NOTES AND CONDITIONS
A
The console has a nominal output level of +4dBu: all input sensitivities are
relative to this: i.e. with line input gain set to 'O', an input of OdBu, will give an
output of +4dBu at any group or mix output and, a sensitivity of +4dBu gives unity
gain from input to output.
B
Noise measurements are taken with 22Hz-22kHz bandwidth, average reading
response.
C
Distortion measurements are made with an input of +20dBu (line inputs at unity
gain) giving an output of +20dBu. The analyser reads THD+N with an average
response, over a IOHz-30kHz bandwidth.
D
Frequency response and E.Q. measurements are made with an input ofOdBu to
line inputs at unity gain, outputs are quoted relative to OdBu.
E
Crosstalk and rejection measurements are made with an input level of +20dBu
(line inputs at unity gain) giving an output of +20dBu on the active signal path. The
ratio quoted is relative to +20dBu output.
F
Gain tolerance +/-l.5dB or IO% of indicated value, which ever is the greater.
G
All crosstalk and rejection figures stated with l 6 channels routed to the measured
output, where applicable.
H
Mix noise figures are stated in two ways:
•
Bus residual noise: Noise measured at the output with faders at unity and no
channels routed.
•
Mix bus noise: Noise measured at the output with 36 channels routed, faders
down.
62
Appendices
Advertisement
Table of Contents
