SoundCraft Vienna II User Manual page 32

25
22
20
18
28
.
~
0l
EQl
~
• 81
-~ =~
(Q)
24
21
[
16
Output Control
The signal to the groups, mix and auxiliaries is controlled by the mute circuitry, the
VCA (VCA Modules only) and the input fader.
15
The CUT switch, which has an integral red LED, mutes the module, turning
the signal to the mix, groups and post-mute or post-fade auxiliaries off.
16
The mute switches Ml - 8, which have integral red LEDs, assign the module
to the eight master mute buses; when the module is muted by the mute buses, the
CUT switch flashes.
17
The SAFE button, which has an integral amber LED, prevents the module from
being muted by the mute buses or the solo system or both, according to internal
jumper position. The default setting is both.
18
The post-fade level is controlled by a 100mm stereo Fader with lOclB of gain
at maximum, and (on VCA modules) the VCA system.
19
The VCA SELECT thumbwheel switch (VCA Modules only) assigns the
input to one of the eight VCA groups; setting
'O'
by-passes the VCAs. If the CUT
switch on the assigned VCA master is pressed, the channel is muted and the CUT
switch flashes.
Normally, the SOLO switch, which has an integral amber LED, feeds the pre-fade,
pre-mute signal to the Control Room and Phones outputs, replacing the selected
monitor source. If Solo In Place is selected on the Master Module, pressing SOLO
does not affect the monitoring, but mutes all other inputs. If the module is selected
SIP SAFE, then SOLO with SIP selected feeds the stereo post-fade, post-balance
signal to the Control-room and 'phones, replacing the selected monitor source.
20
The centre-detented BALANCE pot controls the relative level of the left and
right channels sent to the mix and groups. The control has unity gain at the centre
position, with 4.5dB of gain when turned fully one way, and cutting the signal when
turned the other.
21
The group routing buttons 1 - 8, which have integral green LEDs, route the
post-balance signal to the eight group buses, odd numbers fed from the left channel
and evens from the right.
22
The
L/R
button, which has an integral red LED, routes the stereo signal to the
L/R
mix bus.
23
The MONO button, which has an integral amber LED, routes a mono sum of
the postfade left and right signals to the mono mix bus.
Aux Outputs
24
A mono sum of the left and right signals is sent to the auxiliary buses 1 - 8 via
individual level pots, they are activated in pairs using the associated ON switch.
Stereo Input Module