Table of Contents
Advertisement
Jumper Options
Stereo Input Module
25
The sends are normally sourced post-fade; however they may be individually
switched pre-fade by the PRE buttons, which have integral green LEDs. The
pre-fade signal may be sourced pre-EQ and insert, pre-mute or post-mute using
push-on jumpers.
Aux sends 7 and 8 are normally mono sends; push-on jumpers allow them to be
used as a stereo pair: Aux 7 is fed from the left channel, Aux 8 from the right channel.
Signal Monitoring LEDs
26
The green -30 signal active LED illuminates when the a signal of -30dBu or
greater is present at the output of the left or right input amplifiers.
27
The red PEAK LED illuminates when the signal level exceeds +14dBu
(internal) at the output of the input amplifier, the output of the EQ or the post fade
amplifier on either left or right channels.
Metering
If metering is fitted, a 16 segment bargraph in the overbridge reads the pre-insert,
pre-EQ signal; the higher of the left and right channels is displayed.
Function
Insert Left
JMPI, JMP3, JMP6
JMP2, JMP4, JMP5
Insert Right
JMPI0I, JMPI03, JMPI06
JMP I 02, JMP I 04, JMP 105
SFE Switch
JMP7
JMP8
Options
IN for post-EQ
IN for pre-EQ
IN for post-EQ
IN for pre-EQ
SOLO SAFE
MUTE SAFE
Default
by-passed
by-passed
both
Aux 16 Presource
post-mute
JMPJO
IN for pre-EQ
JMPI l
IN for pre-mute
JMPI 2
IN for post-mute
Note: only one of the above three jumpers should be fitted at one time.
Aux 7 PRE
source
JMP21
JMP22
Aux 7 POST source
JMP23
JMP24
Aux 8 PRE source
JMP25
JMP26
Aux 8 POST source
JMP27
JMP28
mono
IN for mono (follow Aux l-6)
IN for stereo (left post-mute)
mono
IN for mono
IN for stereo (left)
mono
IN for mono (follow Aux 1-6)
IN
for stereo (right post-mute)
mono
IN for mono
IN for stereo (right)
29
Advertisement
Table of Contents
