Table of Contents
Advertisement
Steps
1. Place the antennas into the slots on the palm-rest and keyboard assembly.
2. Route the antenna cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the antenna cable to the palm-rest and keyboard assembly.
4. Align the screw holes on the right antenna with the screw holes on the palm-rest and keyboard assembly.
5. Replace the four screws (M2x2) that secure the right antenna to the palm-rest and keyboard assembly.
6. Align the screw holes on the left antenna with the screw holes on the palm-rest and keyboard assembly.
7. Replace the four screws (M2x2) that secure the left antenna to the palm-rest and keyboard assembly.
Next steps
1. Install the
system
board.
2. Install the
display
assembly.
3. Install the
I/O
board.
4. Install the
fan
2.
5. Install the
fan
1.
6. Install the
heat
sink.
NOTE:
The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
7. Install the
M.2 2230 solid-state drive
52
Disassembly and reassembly
or the
M.2 2280 solid-state drive
from the SSD2 slot.
Advertisement
Table of Contents
