Solid-State Drive In Ssd2 Slot; Removing The M.2 2230 Solid-State Drive From The Ssd2 Slot - Dell EMC Precision 5750 Service Manual

Steps
1. Align the notch on the solid-state drive with the tab on the SSD1 slot.
2. Slide the solid-state drive into the SSD1 slot.
3. Using the guide post, place the solid-state drive thermal bracket over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
Next steps
1. Install the base cover.
2. Install the battery
3. Follow the procedure in

Solid-state drive in SSD2 slot

Removing the M.2 2230 solid-state drive from the SSD2
slot
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed in the SSD2 slot.
NOTE: Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2
2280 solid-state drive in SSD2 slot.
After working inside your computer.
Before working inside your computer.
Disassembly and reassembly 25