Back Panel - NETGEAR GS716TP Hardware Installation Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Table 2. Front panel LEDs (Continued)
LED
LED Mode LED
RJ-45 LEDs for ports 1–16
The LED behavior depends
on the position of the LED
Mode Select button.
Link and ACT LEDs for ports
17 and 18

Back panel

The back panel provides a Kensington lock and AC power receptacle. (The switch uses
a fixed, internal power supply.)
The following figure shows the back panel for model GS716TP. The AC receptacle label
states 100-124V~50/60Hz, 3.8A max.
Figure 3. Back panel model GS716TP
The following figure shows the back panel for model GS716TPP. The AC receptacle
label states 100-124V~50/60Hz, 6A max.
Figure 4. Back panel model GS716TPP
Hardware Overview
Description
Solid green. The port LEDs function in Ethernet Mode.
Solid yellow. The port LEDs function in PoE Mode.
The LED Mode Select button is set to Link/ACT mode:
Off. No Ethernet link is established.
Solid green. A valid 1000 Mbps Ethernet link is established.
Blinking green. The port is transmitting or receiving packets at 1000 Mbps.
Solid yellow. A valid 10 Mbps or 100 Mbps Ethernet link is established.
Blinking yellow. The port is transmitting or receiving packets at 10 Mbps or 100
Mbps.
The LED Mode Select button is set to PoE mode:
Off. The port is not delivering PoE.
Solid green. The port is delivering PoE.
Solid yellow. A PoE fault occurred. For more information, see PoE troubleshooting
suggestions on page 34.
Off. No SFP module link is established.
Solid green. A valid 1000 Mbps link is established.
Blinking green. The SFP port is transmitting or receiving packets at 1000 Mbps.
14 Hardware Installation Guide