NETGEAR GS716TP Hardware Installation Manual page 26

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
To check the package contents:
1. Place the container on a clean flat surface, and cut all straps securing the container.
2. Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4. Verify that the package contains the following items:
Number Item
1 Model GS716TP or model GS716TPP switch.
2 AC power cable (varies by region).
3 Screws for rack-mounting:
• Eight small screws to attach the brackets to the switch (four small screws for each side).
• Four large screws to attach the brackets to the rack (two screws for each side).
4 Two brackets for rack-mounting.
5 Installation guide.
6 Rubber protection caps, which are already installed in the SFP sockets. If you install an SFP
transceiver module, you must remove the cap from the SFP socket.
7 Rubber feet for desktop or table installation.
5. If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
Installation 26 Hardware Installation Guide