Sensor Display (For Service Only); System Operating Language; Running System Reports - X-Rite Macbeth Lighting SpectraLight QC Operation Manual

S p e c t r a L i g h t Q C

Sensor Display (for service only)

The sensor display feature displays various lamp, input, temp., etc. sensor data in main menu screens.
NOTE: The sensor data can only be viewed if the "Sensor Monitor" option in the System Settings is enabled.
Refer to the System Setting section earlier in this manual for details.
1. Use the up (▲) and down (▼) arrow switches to select the desired sensor data screen.
2. Select the desired lamp source from main menu.
NOTE: You cannot change the sensor screen if a visible switch is active. In this case use MORE to go to next
main screen.

System Operating Language

The operating language of the unit can be set at the main menu level without the need to enter the Configuration
mode.
1. Make sure the main power switch is off.
2. Press and hold the up (▲) arrow switch and turn on the main power switch under the front edge of the
luminaire. Hold the arrow switch until the language menu appears.
3. Use the up (▲) and down (▼) arrow switches to highlight the desired language and then press the OK
switch.

Running System Reports

The SpectraLight QC application can produce a conformance report and lamp report on the system. Refer to the
pages that follow for detail information of the reports.
1. Launch the SpectaLight QC application (Programs->X-Rite->SPL QC).
System Report
Before viewing a new system report, you must run a test on the lamps. The lamp test will take up to 10
minutes to complete. Refer to the System Information (INFO) section earlier in this manual for the procedure.
2. Click the System Report (pdf or xml) button to run and view a report on all the system lamps.
32