Reset Lamp Hour Counter And Lifetime (Rlamp) - X-Rite Macbeth Lighting SpectraLight QC Operation Manual

S p e c t r a L i g h t Q C

Reset Lamp Hour Counter and Lifetime (RLAMP)

The Relamp screen displays the hours and cycles remaining for each lamp in the system. From this screen, the
user can reset hours/cycles, select type of lamp, change EOL (End Of Life) parameters and add lamp serial
numbers.
1. Press the RLAMP switch to access the Relamp screen.
2. Use the up (▲) and down (▼) arrow switches to view the hours/cycles remaining for each lamp.
NOTE: The ALL option displays the sum of all lamps hours and cycles.
Resetting Hours/Cycles
This option is used to reset the lamp hours and cycles after a new lamp is installed.
1. To reset, use the up (▲) and down (▼) arrow switches to highlight desired lamp.
2. Press the RESET switch and then the YES switch to reset the numbers.
3. Press the EXIT switch to exit the screen.
Selecting Type of Lamp
Select the lamp type installed from the list. If the lamp type is not in the list, please consult your technical
support. NOTE: This setting should only be used if changing the lamp type from the factory configuration.
1. To set type, use the up (▲) and down (▼) arrow switches to highlight the lamp location.
2. Press the TYPE switch to access the Select Type screen.
3. Use the up (▲) and down (▼) arrow switches to highlight the lamp type.
4. Press the OK switch to save the selected type to the lamp location.
Entering a lamp serial number
A lamp serial number can be a maximum of 15 characters. The number to enter is a Macbeth alphanumeric
number located on the lamp or lamp packaging.
1. To enter a serial number, use the up (▲) and down (▼) arrow switches to highlight the lamp location.
2. Press the SN # switch to access the serial number screen.
3. Use the up (▲) and down (▼) arrow switches to highlight the lamp location.
DL select the left or right lamp location.
•
18