Moving Lamp Switch Order And Auto-Sequencing The Light Sources (Sel) - X-Rite Macbeth Lighting SpectraLight QC Operation Manual

S p e c t r a L i g h t Q C
1. Use the up (▲) and down (▼) arrow switches to highlight the switch you want to disable or enable.
Press the TOG switch to enable or disable the switch. (NOTE: Disabled switches appear grayed out in this
2.
screen and do not appear on the main menus).
Continue with additional switch settings.
3.

Moving Lamp Switch Order and Auto-Sequencing the Light Sources (SEL)

The Select function is used to set the lamp switch locations on the two main menu screens. The "1-1" position
refers to main menu screen 1 and switch number 1 (left switch). The "1-2" position refers to main menu screen 1
and switch number 2 position and so on. Refer to the following page for switch location details.
1. Use the up (▲) and down (▼) arrow switches to highlight the switch to move.
Press the SEL switch. The highlight over the selected switch flashes indicating it is selected.
2.
3. Use the up (▲) and down (▼) arrow switches to move the switch name (i.e., DL) to the desired menu
location.
Press SEL switch again to set the location.
4.
Continue with additional switch locations.
5.
Main menu switch
position diagram
Setup Auto Sequence (PROG)
The SpectraLight QC can be programmed to run a sequence of light sources for the selected profile, each for
a specified period of time (1-999 seconds).
1. Press the PROG switch to access the auto sequence screen for the selected profile.
2. Use the up (▲) and down (▼) arrow switches to highlight step 1 on the screen.
3. Press the SRC switch to access the Select Source screen.
4. Use the up (▲) and down (▼) arrow switches to highlight the desired lamp source for step 1 in the sequence.
If no source is required for the step, select OFF. Press the OK switch to save selection and exit.
5. Press the TIME switch to access the Change Time screen.
Use the up (▲) and down (▼) arrow switches to select the amount of time in seconds that the first lamp will
remain on. NOTE: Holding down the switch quickly increments through the values.
6. Press the OK switch to save selection and exit.
22
Main Menu 1
1-2
1-1 1-3 1-4
Main Menu 2
2-2
2-1 2-3 2-4