X-Rite Macbeth Lighting SpectraLight QC Operation Manual page 19

Sensor Enabled, Disabled
Monitor
Switch Name Generic, Lamp Type
EOL Off, 80%, 85%, 90%,
Pre-warning 95%
Time Format 12H, 24H
Operation SPL QC, Control Box
Mode
Password Disabled, Enabled
RF Remote Disabled, Enabled
RF Remote 0 to 7
Addr.
Auto-Off Timer 0 to 999 minutes
(min)
Standby Timer 0 to 999 minutes
(min)
Message 0 to 255
Codes
Message 0 to 100
Repeat
Key Repeat 100 to 999
Time(ms)
2. Use the up (▲) and down (▼) arrow switches to highlight the desired option.
3. After the option is highlighted, press the EDIT switch to access the editing screen.
4. Select desired option or value for the system settings. Refer below for additional information on editing the
system settings.
To select option or value:
Use the up (▲) and down (▼) arrow switches to highlight the option or select a value.
•
Press the OK switch to save the selected option/value.
•
5. When finished with the system settings, press the EXIT switch to exit the System Settings screen.
Disabled When enabled it displays lamp, input, temp., etc.
sensor data in main menu. Use the up (▲) and
down (▼) arrow switches to view the data.
Lamp Type Allows you the option to display the type of lamp
used (i.e., TL84, CFW, etc.) or display the generic
lamp name (i.e., FL1, FL2, etc.) that appears
above the switches.
Off Set end of lamp life (EOL) pre-warning
percentage.
24H Set time format.
SPL QC Set the SPLQC or control box mode. Select
"Control Box" mode if you are setting up a control
box.
Disabled Enable or disable password protection for the
Administration (ADMIN) Setup.
Disabled Enable or disable the use of the optional remote
control.
0 Set remote control address code to match the
remote control dipswitch setting. Refer to the
Remote Control Operation section later in this
manual to setup the remote control.
5 Set the amount of time in minutes that the DL, HZ,
and HL lamps change to the FL1 lamp. Set to "0"
if you do not want the lamp change.
30 Set the amount of time in minutes that the unit
goes into standby after the last button was
pressed. Any button pressed on the display panel
will reactivate the unit.
100 Messages appear on the display as codes; 1-99
for Error and Warning, 100-255 for information.
0 Number of times the same message will appear
on the display before it ends.
200 Set key automatic repeat interval. Press and hold
the key will produce multi-click events.
S p e c t r a L i g h t Q C
17