Connecting Procedure Of Cp-160; Installation Ipop Circuit Board; Installation Of Ip-100E - JUKI SC-510 Series Engineer's Manual

(3) Connecting procedure of CP-160

(4) Installation IPOP circuit board

45°
IPOP circuit
board

(5) Installation of IP-100E

1) Exclusive connectors are prepared for connection of
2) Paying attention to the orientation of the connector
1) Loosen two screws in the front cover of control box
2) Remove connectors and ground wire of the circuit
3) Place the front cover at an angle of approximate 45°,
(Caution) Do not draw the front cover forcibly since
4) Securely insert CN41 of IPOP circuit board supplied
5) Fix IPOP circuit board with two screws
CN41
6) Place the front cover at an angle of approximate 45°,
(Caution) When removing IPOP circuit board, turn
CN121
– 85 –
the connector for CP-160.
, connect it to connector
circuit board. After connecting, securely lock the con-
nector.
and open the front cover
board attached to the front cover/
draw it in the direction of arrow, and remove it from
the box main unit.
there is the possibility that the click of front
cover is broken.
as accessories to white connector CN41 on the front
cover circuit board from the upper side.
as accessories.
attach it to the box main unit, and attach connectors
and ground wire which have been removed in step
2).
OFF the power and remove it after 5 min-
utes or more have passed.
1) Install operation panel
ing screws , washers
supplied as accessories.
(Caution) Do not disassemble the operation panel
to prevent it from breakage.
2) Set the panel cord same as the other machine head
cords, insert it to CN121 of the control box, and lock
it.
3) Put it together with other machine head cords and
bundle them with clip band
4) Close the front cover and tighten two screws, while
taking care not to put the cords in the front cover.
(CN38) located on the
supplied
on the machines head us-
and spring washers
.