Error Code List - JUKI SC-510 Series Engineer's Manual

(1) Error code list

No. Description of error detected
* SmartMedia cover open
E000 Execution of data initialization
(This is not the error.)
E003 Disconnection of synchronizer
connector
E004 Synchronizer lower position sensor failure
E005 Synchronizer upper position sensor failure
E007 Overload of motor
E008 Machine head connector
failure(Resistance pack)
E011 A SmartMedia card uninserted
*
E012 Read error
*
E013 Write error
*
E014 Write protection
*
E015 Format error
*
E016 Beyond external media capacity
*
E019 Beyond file size
*
E032 File compatibility error
*
E302 Tilt detection
(MF : thread trimmer knife sensor)
(At the time of safety switch
operation)
E331 Tape cutter (TC03)
Cutter sensor simultaneously
enabled
E332 Tape cutter (TC03)
Cutter sensor simultaneously
disabled
E499 Simplified program data error
E704 Type error of simplified program
or sewing machine data
E730 Encoder failure
E731 Motor hole sensor failure
E733 Motor reverse rotation
(Caution) Items marked with * are applicable only to IP-100E.
Cause of occurrence expected
• The SmartMedia slot is open
• When the machine head is changed.
• When the initialization operation is executed
• When position detection signal is not input
from the sewing machine head synchronizer.
• When the synchronizer has broken.
• When the machine head is locked.
• When sewing extra-heavy material beyond
the guarantee of the machine head.
• When the motor does not run.
• Motor or driver is broken.
• When the machine head connector is not
properly read.
• A SmartMedia card has not been inserted.
• Data on a SmartMedia card cannot be read.
• Data cannot be written into a SmartMedia
card.
• The SmartMedia is write-protected.
• The SmartMedia is unformattable.
• Short of SmartMedia capacity
• The file is too large.
• The file is not compatible.
• When tilt detection switch is inputted with
the power ON.
• Position of thread trimmer knife is improper.
• Defective cutter sensor
• Defective assembly
• Command parameter data is out of the range.
• Adifferent type is entered for the program
or data.
• When the motor signal is not properly
inputted.
The motor rotates at the speed of more than
500rpm in a direction opposite to that of
indication.
– 117 –
Items to be checked
• Close the cover of the slot
• Check the synchronizer connector (CN33,
CN43) for loose connection and disconnection.
• Check whether the synchronizer cord has broken
since the cord is caught in the machine head.
• Check whether the thread has been entangled
in the motor pulley.
• Check the motor output connector (4P) for loose
connection and disconnection.
• Check whether there is any holdup when turning
the motor by hand.
• Check the machine head connector (CN32)
for loose connection and disconnection.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Check whether machine head is tilted without
turning OFF the power switch (operation of
sewing machine is prohibited for safety).
• Check whether tilt detection switch cord is caught
in the machine.
• Check whether tilt detection switch lever is
caught in the machine.
• Is air pressure appropriate?
• Is air pressure appropriate?
• Enter the simplified program again.
• Disable the simplified prgram.
• Turn off the power.
• Check the motor signal connector (CN30) for
loose connection and disconnection.
• Check whether the motor signal cord has broken
since the cord is caught in the machine head.
• Encoder wiring of the main shaft motor is
wrong.
• Power wiring of the main shaft motor is
wrong.