Installing The Wiring And Electrical Kits - Dometic 9500E Installation Instructions Manual

INSTALLATION
B. Installing The Wiring And Electrical Kits
 Failure to obey the following warnings could result in death or serious injury:
• ELECTRICAL SHOCK HAZARD . Disconnect 120 VAC power from RV .
• IMPACT OR CRUSH HAZARD . Do NOT install product without also installing an ignition/safety interlock system . Otherwise, acci-
dental operation during transit could occur .
• FIRE OR ELECTRICAL SHOCK HAZARD . Make sure there are no obstacles (wires, pipes, etc .) inside RV's walls, roof, or floor . Shut
OFF gas supply, disconnect 120 VAC power from RV, and disconnect positive (+) 12 VDC terminal from supply battery BEFORE
drilling or cutting into RV .
Failure to obey the following notices could damage product or property:
• Disconnect the positive (+) 12 VDC terminal from supply battery . Otherwise, damage to unit could occur .
• Do NOT pinch wiring or allow wiring to rub against sharp edges . If wiring is damaged, it MUST be replaced by a qualified service
technician .
• ALWAYS seal wiring against weather and moisture where wiring enters RV's walls, roof, or floor . Otherwise, water leakage could
occur .
Wire colors noted within this section are industry standard . Some RV manufacturers use different colors . Refer to RV wiring sche-
matics for more detail . Use the appropriate wire gauge for each wire run .
STEP 1
15 A Fused
Power Supply
LED Strip
(Optional)
Awning
Motor
Retract
Awning Switch
(Optional Installer Supplied)
(MOM-OFF-MOM)
Extend
• Inside the RV, route one BLACK wire and one RED wire from the 12 VDC power supply to the receiver location and connect .
• If applicable, install the wiring for the ignition/safety interlock . Connect the (+) 12 VDC ignition terminal to the ORANGE re-
ceiver wire .
• Wire the receiver to the awning motor . Connect one BLUE wire and one BROWN wire from the location of the receiver to the
awning motor location . Use a wiring length long enough to pass through the outside RV wall for connection to the awning .
• If applicable, wire the receiver to the LED lights . Connect one WHITE wire and one RED wire from the location of the receiver to
the LED light location . Use a wiring length long enough to pass through the outside RV wall for connection to the LED lights .
15 A Inline Fuse
Red
Black
Brown
Blue
Ignition
(Interlock)
Black
Green
Red
(Not Used)
On/Off Switch
Optional LED Switch
(Installer Supplied)
Brown (-)
Blue (+)
Orange
RJ 11 Cable
Yellow
6
Red (+)
Black (-)
Red (+)
White (-)
Receiver