Circuit Names; Location Name; Cycle Time - Dataprobe IP-28 Series Manual

iP-28xx
Select S to access the setup Menu
Setup

1. Circuit Names

2. Location Name

3. Password

4. Cycle Time

5. Baud Rate
X. Return to the Main Menu
Enter > x
Circuit Names
Each circuit can be identified with a 20-character name for easy identification. Select 1 from the Setup menu. A list of all
eight circuits is displayed with the option to change any circuit name. These names are used in both the telnet screens and
web page.
Location Name
Each power strip can be identified by a Location name that appears at the top of each telnet and web page. Select 3 from the
Setup Menu to set the Location, up to 20 characters.
Password
This selection offers an opportunity to change the password required for Telnet and Web Browser Access. To change the
password, Select 4 from the Setup Menu. The password can be up to 8 characters and is case sensitive. Enter the current
password, followed by the new password, then confirm the new password. Please remember your password. If you forget
your password, contact Dataprobe Tech Support 201-967-8788 or tech@dataprobe.com
Cycle Time
This feature selects the time in seconds for a Cycle command for any of the outlets. This would typically be used to support
power-off-reset for power control applications. To set the cycle time, select 5 from the Setup Menu. The Cycle Time can be
from 01 to 99 seconds. Use Leading zeros when entering 01 to 09 seconds.
Baud Rate
Select 5 to cycle though the available choices for baud rate (2400, 9600, 19200)
- Location Name
- 10
- 19200
Page 7