Knx Comunication Objects; Single Dali Device Signals - HMS Networks Intesis DALI User Manual

KNX – DALI
TM
Intesis

KNX Comunication Objects

2.3.1 Single DALI device signals

There are up to 94 signals for each DALI device or ballast.
Supported signals vary according to device type, configured through Intesis MAPS.
Following abbreviations are done in the table:
•
FL: Fluorescent light (device type 0)
•
EML: Emergency light (device type 1)
•
LED: LED module (device type 6)
Ballast /
Device Type
TOPIC
COMM
x x x Ballast / Lamp Failure
ERR
x x x Update All ECG Status
x x x Ballast Status
x x x Actual Level
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
NAME LEN
DPT_NAME
1 bit DPT_Alarm
DPT_Switch
1 byte Unsigned Value
1 byte DPT_Scaling
FLAGS:
If marked with a black "x", it will be enabled by default and couldn't be disabled.
If marked with red "x", column will be disabled by default but could be enabled by user.
If marked with blue "x", column will be enabled by default but could be disabled by user.
DATAPOINT TYPE FLAGS
DPT_ID U T Ri W
1.005 T
1.001 U T Ri W
5.x T
5.001 T
User Manual r1.1 EN
FUNCTION
R
0-OK
R
1-Ballast / Lamp Failure
0-Update Finished
R
1-Trigger Update
b7-PwrCycle
b6-MissShAdd
b5-ResetSt
b4-FadeRun
R
b3-BallLimErr
b2-LampPwrOn
b1-LampFail
b0-BallFail
0 to 100 %
R
URL https://www.intesis.com
8 / 34