Operating Functions - Triton Hawaii 2 Installation And Operating Instructions Manual

IMPORTANT: It is advisable to be certain that
the showering temperature is satisfactory by
testing with your hand before stepping under the
showerhead.
CAUTION: It is recommended that persons who
may have difficulty understanding or operating
the shower controls should not be left unattended
while showering. Special consideration should be
given to young children and the less able bodied.
• There will always be a time delay of a few
seconds between selecting a flow rate and
the water reaching the stable temperature for
that flow rate.

OPERATING FUNCTIONS

Low water pressure cut-out
If the water pressure falls below the minimum
required for correct operation of the shower,
power will be switched off to the heating
elements preventing any maintained
temperature rises (water will continue to flow).
Power will automatically be restored when
adequate water pressure returns.
Temperature limiter
During normal operation if an overheat
temperature is sensed, power to the elements
will be reduced. Water will continue to flow.
When the temperature has cooled sufficiently,
power to the elements will be automatically
restored to the previous setting at the time of
interruption.
Safety cut-out
The unit is fitted with a thermal cut-out safety
device. In the event of abnormal operation
which could cause unsafe temperatures within
the unit, the device will disconnect the power
supply to the heating elements. It will require a
visit from a qualified engineer to determine the
nature of the fault and replace the safety cut-out
device, once the unit has been repaired.
High
NOTE: In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances, the
unit MUST be switched off at the isolating
switch when not in use.
15
SECTION
Continued
Fig.23
Temperature knob
Fig.24
Economy
Power knob
10