Commissioning Procedure - Triton Hawaii 2 Installation And Operating Instructions Manual

!! IMPORTANT !!
WARNING
Before normal operation of the shower, it
is essential the following commissioning
procedure is completed correctly.

COMMISSIONING PROCEDURE

The first operation of the shower is intended
to flush out any remaining unit debris, and
to make sure the heater unit contains water
before the elements are switched on.
This operation MUST be carried out WITH
the flexible hose screwed to the outlet but
WITHOUT THE SHOWERHEAD ATTACHED.
Make sure the outlet of the flexible hose is
directed to waste.
• Check the WATER and ELECTRICITY supply
are turned OFF to the unit.
1. Make sure the POWER KNOB is set to
'Economy' (fig.17).
2. Rotate the temperature knob fully
anti-clockwise to number '10' (fig.18).
IMPORTANT: Leaving the control at any position
other than '10' may cause the PRD to operate.
• Turn the water supply back ON at the
isolating stopvalve.
3. Wait until water starts to flow from the flexible
hose, then slowly rotate the temperature
control clockwise to '1' (fig.19).
4. It will take approximately thirty seconds for a
smooth flow of water to be obtained whilst
air and any debris is being dispersed from
the shower. When a smooth flow of water is
obtained, rotate the temperature control from
'1' to '10' and back again several times to
release any trapped air within the unit (fig.20).
• Once the flushing out has been completed,
stop the water flow by rotating the
temperature control fully clockwise to the
'STOP' position.
• Fit the showerhead to the flexible hose and
place in the holder.
• Switch on the electricity supply to the shower
at the isolating switch.
• The shower is now ready for normal
operation.
COMMISSIONING
Power knob
13
SECTION
check list
Fig.17
1.
Power
knob to
Economy
position
Fig.18
2.
Turn the
temperature
knob to '10'
Temperature knob
Fig.19
3.
Turn the
temperature
knob to '1'
Temperature knob
Fig.20
4.
Turn the
temperature
knob '1' to '10'
Temperature knob
9