Fitting The Cover - Triton Hawaii 2 Installation And Operating Instructions Manual

SECTION
8
check list
Fig.14
Installation - FITTING THE COVER

FITTING THE COVER

• Position the power selector on the cover to the
• Make sure the power selector spindle is aligned
Economy
position
• To make sure that the temperature knob is
• The valve is now in the closed position.
• Remove the cover and position the temperature
Fig.15
• Replace the cover squarely to the backplate and
Power
selector
• While applying slight pressure to the cover, secure
DO NOT switch on the electricity supply to
the shower until the commissioning has
been carried out.
• Fit the Riser Rail and Kit (see kit instructions).
Temperature
control
Fig.16
'ECONOMY' position (fig.14).
with the screw at the 6 o'clock position - as shown
in (fig.15).
correctly positioned on the stabilising valve,
temporarily place the cover in position so that the
splines engage and rotate the temperature knob
fully clockwise until a 'stop' is felt(fig.15).
knob so that it points towards the 'STOP' position
(fig.16).
guide into position so that the knobs locate
correctly into the spindle. Should any difficulty
arise, recheck the points above.
in position with the retaining screws.
Cover
WARNING!
The PRD tube, MUST be
positioned correctly when
fitting the cover. Failure to
do so may damage the unit
if the PRD operates and will
invalidate product warranty
and approvals.
12
PRD
Tube