Fitting The Remote Pack Cover - Triton Aspirante Installation And Operating Instructions Manual

Fig.30
Fig.31
Fig.32
Aspirante Remote electric shower
Control
cable
clamp
18
FITTING THE CONTROL PANEL
Hook the control panel over the lugs on the
mounting bracket (Fig.31) and slide down into
place, making sure the control cable does not
get trapped.
Secure in place with the single screw at the
bottom of the control panel (Fig.32).
Note: To remove the panel once fitted, remove
the single retaining screw, and lift off from the
wall bracket lugs.

FITTING THE REMOTE PACK COVER

Refit the trimplate and secure with the two
screws.
Before replacing the cover, check on the PCB
that the purge pin is located on its two pins
– the factory set position, see Fig.34.
Locate the tags on the cover into the holes on
the backplate and guide into position. Secure
the cover in position with the three retaining
screws.
Note: DO NOT fully tighten at this stage as
the remote pack cover is fitted temporarily
in order to carry out the commissioning
procedure.
WARNING
COVER RETAINING SCREWS
ONLY the SUPPLIED SCREWS should be
used. The use of none supplied screws WILL
invalidate product specifications & warranty.