Midea MHC-96HWD1N1(A) Service Manual page 66

R410A Full DC Inverter Split Duct Type Technical Manual

Wired controller initial parameter setting
Change the related functions of the controller through adjusting the initial parameters.
The wired controller initial parameter includes two codes 'XY". The first code 'X' means the
function class, the second code 'Y' means detailed configuration of this function.
Step1: Simultaneously press the mode button
Step2: The value of the first code 'X' is '0', press the temperature setting buttons
Step3: After setting the second code value, press Quiet/OK button
Step4: When the first code value is '6', press Quiet/OK button
First
code
Cooling-only/Heat
0
selection
Indoor unit communication
1
address setting
2 Power-off memory
3 Filter cleaning reminding
5 Remote receiving function
Centigrade/Fahrenheit
6
display
Notes: The second code of the filter cleaning reminding is 2500hours, which as default.
65
controller for 5 seconds to enter the parameter setting state.
to adjust the second code value.
code to the next value.
parameters setting.
The parameter setting table
Function
pump
and fan speed button
0
Heat pump (Default)
Yes (Default)
Yes (Default)
Cancel the reminding
function
Yes (Default)
Centigrade (Default)
MCAC-UTSM-201503
to switch the first
again to exit the
Second code
1 2
Coolin
\
g only
None \
None \
1250 2500 5000
hours hours hours
None \
Fahre
\
nheit
of the wired
and
3 4
\ \
\ \
\ \
10000
hours
\ \
\ \