Midea MHC-96HWD1N1(A) Service Manual page 58

R410A Full DC Inverter Split Duct Type Technical Manual
than 10 hours, each press
setting is 24 hours.
After finish adjusting the timer on setting, press the button
confirm and exit the timer on setting.
Under the timer on setting status, press the timer/clock setting button
timer off setting status, and the screen will display
The setting method of timer off is the same as the timer on.
Under timer setting state, set the timer on and the timer off to be 0.0h can cancel timer on and
time off.
Notes: If the wired controller has been set timer on/off, press the ON/OFF to turn on or turn off the unit
then the timer will be canceled simultaneously.
7) Clock setting
Press the timer/clock button
status.
The hour position of the clock will flash, and can press
After finishing the hour setting, press left button
minute position setting, then the minute position will flash, press
minute value.
After finish the clock setting, press the
the setting state.
8) Quiet operation
Under COOL, HEAT, FAN modes, press the
used to reduce the running noise through setting the fan speed to low.
Notes: Under AUTO, DRY mode, the fan speed is auto and the
57
or will increase or decrease 1 hour, the maximum timer
setting for 3 seconds, and then enter into the clock setting
button or wait for 5 seconds to confirm and exit
button to set into the quiet operation, it is
MCAC-UTSM-201503
or wait for 5 seconds to
, then enter into the
and .
and to adjust the hour value.
or right button
and
button does not work.
to switch to
to adjust the